Page 1 of 1
ANSI
Posted: Sun Jun 28, 2009 2:46 pm
by Franchise_24
One big concern I've had since starting the WG BBS is that if a user accidently says NO to ANSI at signup, I cannot for the life of me find a way or where to change it to turn ANSI back on. In their account settings it still says ENGLISH/ANSI but there are no colors. Any ideas?
Re: ANSI
Posted: Sun Jun 28, 2009 8:08 pm
by Gardner Denver
Franchise_24 wrote:One big concern I've had since starting the WG BBS is that if a user accidently says NO to ANSI at signup, I cannot for the life of me find a way or where to change it to turn ANSI back on. In their account settings it still says ENGLISH/ANSI but there are no colors. Any ideas?
Several of the Globals packages have ANSI toggle commands in them. There is also an option in the user account settings to turn ANSI on/off although it has been awhile since I looked and do not remember exactly where it is.
Posted: Sun Jun 28, 2009 9:20 pm
by Malakai
Not all ansi clients allow ansi blinking either. So, what I did was just set the question of:
Is this yellow?
or something like that and took down the blinking part..